Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CAUTION
These instructions must be read and understood before proceeding with the installation and
to avoid any possibility of accident it is essential that the appliances are installed and
operated in accordance with these instructions.
No unit should be installed in a room, van or craft if fixed ventilation is not provided.
No alterations or adjustments should be made to the burners or gas supply pressure by
unauthorised or unskilled persons. In the event of a failure or breakdown of a unit itself, turn
off the gas supply at the cylinder or isolating cock valve for the unit and contact the supplier.
Do not remove any parts from the appliance or substitute alternatives as this may affect the
performance and safety of the appliance.
The installation should be carried out in accordance with the appropriate codes of practice
for the country in which the installation is done.
If aluminium foil is used in the oven, then it must not be allowed to block the oven flue
outlet or smother the burner.
Do not spray aerosols in the vicinity of these appliances while they are in operation.
Do not use this appliance to heat the vehicle or craft.
Turn off the grill once the grill pan has been removed.
Be sure appliance taps are closed before opening cylinder valve.
Be sure to apply ignition source to burner before opening appliance valve.
If you wish to drill the sides for your own gimbals you must first remove the right hand side
for drilling as there is a gas pipe behind this panel.
When a flexible hose is used do not allow the hose to come into contact with the back panel.
In any communication, it is essential to quote the model and number marked on the data
badge on the back of the appliance.
Our policy is one of continuous development and for this reason we reserve the right to
change the product details and specification without prior notice.
INSTALLATION INSTRUCTIONS
This unit should be installed according to the current standards in practice in the country of
installation.
BS 5482 :
Part 2 Installations in caravans and non-permanent dwellings
Part 3 Installations in boats, yachts and other vessels.
BS 6172 :
Code of practice for installation of domestic gas cooking appliances.
THESE APPLIANCES MUST BE INSTALLED BY A COMPETENT PERSON (e.g. a
'Gas Safe' registered gas fitter)
VENTILATION
Adequate ventilation must be provided to ensure the cooker unit works in a safe and efficient
manner. If fixed ventilation is not provided two ventilation openings of 95 cm
provided, one near floor level and one near ceiling level. Do not install cookers and hobs in
areas subjected to strong draughts.
INSTALLATION
The unit should only be installed in the countries indicated on the dataplate using the correct
gas at the indicated pressure as detailed in figure 1.
Figure 1
Category
Gas
mbar
Country
I
28
3+
G30
GB,IE,FR,BE,IT,ES,PT
I
30
NL, SE, FI, DK
B/P
G30
I
G30
50
DE, AT
B/P
Heat Input Rates : H
S (Model Dependant)
Rapide
2.4 kW.
Hob Burner
Semi-
1.6 kW.
Rapide
Auxillary
1.0 kW.
Oven
1.4 kW.
Grill
1.4 kW.
Adjustable feet can be supplied to secure the appliance in position. These are fixed
at the existing screw points / captivated nuts at each corner of the unit and to the base of the
cabinet. (FIG.
2)
If using a gimballing system, ensure the bulkhead is of sufficient strength to hold the weight
of the unit and that the gas inlet pipe is free to move with the unit and at no time will become
stressed or damaged.
This unit must be fixed in place using either the
feet or a gimbal system.
2
must be
Werbung
Inhaltsverzeichnis
