Cutting Techniques - Jean Louis David urbanstyle salon pro J71E Bedienungsanleitung

ved at the back of the hair, start
clipping the top and sides.
• Hold the clipper to the front of
your hair with the teeth pointing
towards the back of your head,
and move the clipper towards
your crown. Repeat as necessary,
moving in rows from the front
and the sides of your head to the
back.
• You should achieve an even
length cut all over your head.
For a shorter back and sides, with
length on the top:
• Attach the longer comb guide
as required for the top of your
hair – your clipper is supplied
with 8 comb guides for 8 cut-
ting lengths from 3-25mm. Each
comb guide is labelled.
• Switch the clipper on, and the
blades will start to move.
• Hold the clipper to the front of
your hair with the teeth pointing
towards the back of your head
and move the clipper towards
your crown. Repeat as necessary,
moving in rows from the front
and the sides of your head to the
back.
• If you then wish to take the back
and sides of your hair to a shorter
length, switch off the appliance
and attach a shorter comb guide.
• Starting at the nape of the neck,
with the comb guide flat against
the head, move the clipper
upwards and outwards over the
area you want to take shorter.
• Repeat on the sides of the hair,
starting with the teeth of the clip-
per pointing upwards and comb
guide flat against the area above
the ear, again moving the clipper
upwards and outwards.
Outlining:
• To tidy up the edges around your
cut e.g. neckline and sideburns,
detach the comb guides.
• Hold the appliances upside
down, so the front of the clipper
is facing towards your head.
• Hold the clipper straight on your
sideburns or neckline and move
the clipper downwards. This will
give you a clean, smooth finish.
BEARD TRIMMER USE
The beard trimmer operates on
two 1.5 V batteries type AAA
(included)
- Open the battery compartment
cover by pushing it down and
sliding it open.
- Insert 2 batteries as indicated in
the battery compartment.
- Replace the cover by pushing it
upward until it clicks into place.
NOTE: If the appliance remains
unused for a while or if the batteries
have run down, remove them from
the unit. These precautions will
extend the life of the product.
WARNING: Only use new batteries.
Do not mix different types of
batteries.

CUTTING TECHNIQUES

This appliance is supplied with
3 comb guides: 2 - 3 - 4 mm (see
comb guide's use)
8