Jean Louis David urbanstyle salon pro J71E Bedienungsanleitung Seite 6

ENGLISH
SALON PRO
HAIR AND BEARD
PROFESSIONAL KIT
FEATURES
1. Hair Clipper:
- 40mm blades:
Moveable
coating for longer life
Fixed Blade: stainless steel
- Taper control with 5-position
lever for fine cut adjustment
- Turbo boost for extra cutting
power when needed most
- 8 x comb guides (grades 1-8)
- Adaptor
2. Beard trimmer:
- 30 mm blades:
Moveable blade: stainless steel
Fixed Blade: stainless steel
- 3 cutting guides: 2 - 3 - 4 mm
- On/Off switch
- Battery operated
3. Cape
4. Barber's comb
5. Cleaning brush
6. Scissors
7. Lubricating oil
8. Storage case
HAIR CLIPPER USE
IMPORTANT INFORMATION
REGARDING THE NI-MH
BATTERIES OF THIS UNIT
To obtain and maintain the
longest battery
possible, allow it to charge for 16
hours before using it for the first
blade: Titanium
autonomy
time and then approximately
every three months.
Full autonomy of the unit will
only be obtained after three
complete recharge cycles.
TO CHARGE THE APPLIANCE:
1. Insert the adaptor into the base
of the appliance, plug in to a sui-
table mains socket and switch
on. The charging indicator will
illuminate when the adaptor is
correctly inserted into the ap-
pliance and connected to the
mains.
2. Once the appliance is fully char-
ged, unplug the adaptor from
the mains.
3. A full charge (16 hours) will
allow you
autonomous use.
4. Before using the trimmer for the
first time, allow it to charge for
16 hours.
5. Subsequent charges should also
be 16 hours.
USE ON THE MAINS
To use the trimmer on the mains,
plug the cord directly into the
unit.
Plug the trimmer, in the OFF
position, into the mains and switch
ON (If the battery is very weak,
wait about 1 minute).
IMPORTANT! Use only the adaptor
that is supplied with the trimmer
Ref. J71E Voltage = 4,5V – Current
1000mA.
6
30 minutes of