Hama TH-140 Bedienungsanleitung Seite 5

5.2Setting and using the alarm function
• In normal time mode, press the MODE button (2) once to set the alarm
function. ALM is shown on the display.
• Press the SET button (3) for approximately 2 seconds. The hours display
begins to ash.
• Press the UP button (4) or the DOWN button (5) to select the hour for the
alarm time and con rm your selection by pressing the SET button (3). The
minutes display begins to ash.
• Repeat the process to set the minutes for the alarm time. Then con rm the
process with the MODE button.
• Press the MODE button (2) twice to go to the start display.
• To activate the alarm function, you must press the MODE button (2) once to
switch to ALM mode. If you press the UP button (4) once, the bell symbol
appears on the display and the alarm is set.
• If you press the DOWN button (5) during the alarm, the alarm will be
interrupted for 4 minutes and then go off again. The (
ashes.
• If no button is pressed, the alarm automatically switches to the snooze
function; the alarm will be likewise interrupted for 4 minutes and then go off
again. The (
• Press any button (except the DOWN button) to stop the alarm/snooze
function.
Note
• When the alarm function is activated, the alarm melody sounds daily at the
selected time.
• To completely deactivate the alarm function, press the MODE button (2) and
then press the UP button (4) three times until the
shown on the display. Press the MODE button (2) twice to return to the start
display. is no longer shown on the display.
5.3Maximum and minimum value (MAX/MIN)
• The base station automatically stores the maximum and minimum indoor
temperature and humidity values.
• Repeatedly press the UP button (4) to switch between the current
temperature, maximum temperature (MAX) and minimum temperature (MIN).
• Press and hold the UP button (4) for approximately 2 seconds to reset the
stored maximum and minimum values.
5.4Hourly reminder alarm
• If you activate the hourly reminder alarm, a signal will sound every hour on
the hour.
• Press the MODE button (2) once to go to alarm mode (ALM).
• Press the UP button (4) twice to activate the hourly reminder alarm.
• If you press the UP button (4) a third time, both the alarm you have set (to go
off at a particular time) and the hourly reminder alarm will be activated. Press
the button a fourth time to deactivate both alarms.
appears on the display if the hourly reminder alarm is activated.
•
appears on the display if both the alarm you have set and the hourly
reminder alarm are activated.
4
:
and ) symbol ashes.
:
and ) symbol
symbol is no longer