Electrical Connection; Mounting The Probe To The Probe Head - Renishaw MH8 Benutzerhandbuch

12 Installation procedure
3.3

Electrical connection

Connection is by means of a 5 pin DIN connector on the side of the
heads (see fi gure 2).
The pin numbering functions are given in the table below:
Pin number
1
2
3
4
5
3.4

Mounting the probe to the probe head

If fi tting a TP20 probe, mount the probe body to the probe head before
fi tting the probe module and stylus.
• Screw the threaded end of the probe into the M8 connector on the
probe head until it is fi nger tight.
• Fit the S1 'C' spanner (supplied) to the location holes in the probe
body and tighten by hand.
• The recommended tightening torque is 0.3 Nm – 0.5 Nm.
Refer also to the user's guide for the probe type being used.
Designation
LED cathode
Ground
LED anode
Probe circuit
Probe circuit
5
4
2
3
1