Installation Procedure; Mounting The Shank On The Probe Head; Mounting The Head On The Cmm - Renishaw MH8 Benutzerhandbuch

3

Installation procedure

3.1

Mounting the shank on the probe head

• Hold the shank in the recess on the top face of the MH8.
• Rotate the shank until 3 screw holes are aligned.
• Fix the shank in place using only the M3 x 5 mm screws
(supplied).
• Progressively tighten using the 2.5 mm A/F hexagon key
(supplied).
3.2

Mounting the head on the CMM

The head will normally be attached to the quill of the CMM using a
standard shank, specifi ed by the CMM manufacturer.
Standard shanks are listed in the section 2.1, 'Part number summary'.
Special or customised mounting arrangements are possible. Please
contact your supplier or Renishaw, for details of our custom products
service.
The mounting must be absolutely rigid, as any movement during
normal operation of the head will add errors to the measurement
system.
If the head is replaced or repositioned in the quill, it will be necessary
to requalify all of the head positions in current use.
Installation procedure 11