Storage; Ordering Accessories - Philips Lumea plus TT3003 Bedienungsanleitung

22
English

Storage

Ordering accessories

Note: Make sure that the contact switches of the safety ring do not get
congested with dirt.
Note: Stop using the appliance when it is no longer possible to clean the
light exit window or the body attachment.
1 Switch off the appliance, unplug it and let it cool down.
Note: The light exit window becomes hot during use. Make sure it has
cooled down before you clean it.
2 To remove the body attachment, put your fingers in the recesses at the
top and bottom and pull gently. The attachment should come off easily.
3 Moisten the soft cloth supplied with the appliance with a few drops of
water and use it to clean the following parts:
-
the light exit window
-
the outside surface of the body attachment
-
the metallic frame inside the body attachment
Note: If water does not clean effectively, use a few drops of
highpercentage alcohol to clean the parts mentioned above.
Note: A contaminated light exit window can look like this picture. Make
sure you clean the appliance before and after each use and, if necessary,
also during the treatment according to the instructions in this section.
4 If necessary, clean the outside of the appliance with the dry soft cloth
supplied with the appliance.
Tip: If it is no longer possible to clean the edges of the attachment with
the cleaning cloth supplied, use a cotton bud instead. Make sure that no
fluff of fibres stay behind on the attachment or on the light exit window.
1 Switch off the appliance, unplug it and let it cool down.
2 Clean the appliance before you store it.
3 Put the appliance in the pouch supplied.
4 Store the appliance in a dry place at a temperature between 0°C and
60°C
To buy accessories or spare parts, visit www.philips.com/parts-and-
accessories or go to your Philips dealer. You can also contact the Philips
Consumer Care Center in your country (see the international warranty leaflet
for contact details).