General Arnings W; Protection Of The Environment; Installation - Hoover H-HOB 300 CERAMIC Gebrauchs- Und Installationsanweisungen

Identification Plate (located under the hob's bottom casing)
1. GENERAL WARNINGS
By placing the mark on this appliance we are assuring
compliance to all European Safety, Health and Environment
requirements which are applicable for this product category.

2. PROTECTION OF THE ENVIRONMENT

This appliance is marked according to European
Directive 2012/19/EU on Waste Electrical and
Electronic Equipment (WEEE).
WEEE contains both polluting substances (which
can cause negative consequences for the
environment) and basic components which can be
reused.It is important to have WEEE subjected to
specific treatments, in order to remove and dispose
properly all pollutants and recover and recycle all
materials.
Individuals can play an important role in ensuring that the WEEE
does not become an environmental issue; it is essential to follow
some basic rules:
• WEEE shall not be threatened as household waste.
• WEEE shall be handled over to the relevant collection points
managed by the municipality or by registered companies. In many
Countries, for large WEEE, home collection could be present.
• In many Countries, when you buy a new appliance, the old one
may be returned to the retailer who has to collect it free of charge on
a one-to-one basis, as long as the appliance is of equivalent
typology and has the same functions as the supplied one.

3 INSTALLATION

.
Installing a domestic appliance it is a complicated operation which, if
not carried out correctly, can seriously have impact on safety of goods,
properties or people. For this reason, it should be carried out by a
professionally qualified person in accordance with technical
regulations.
In the event that this advice it is ignored and installation is carried out
by an unqualified person, the Manufacturer declines all responsibility
for any technical failure of the appliance whether or not it results in
damage of goods or properties or in injury of people or animals.
After having removed the packaging please be sure that the appliance
it is not damaged, otherwise contact the Retailer or Manufacturer After
Sales Service.
Make sure that the furniture in which the appliance will be fitted and all
other furniture in the nearby are made with materials which can
withstand high temperatures (min 100 °C).
In addition, all decorative laminates should be fixed with high-resistance
glue.
Appliance can be installed in a Built-in furniture in "Standard" or "Flush"
mode.
Worktop thickness should be between 25 and 45 mm.
560
+ 2
- 0
Min. 70 mm
490 mm
+ 2
- 0
Standard installation
perimeter
PRODUCT CODE T
mm
523
+ 2
- 0
Flush installation
perimeter
Note: Inner perimeter dimensions are same with standard installation
Leave a distance of at least 55
mm between the hob and the
back wall and of at least 150
mm between the hob and the
vertical furniture or walls in the
lateral side. If a furniture is
installed above the hob, the
minimum distance required is
700 mm.
When installing a hood above
the hob, please consult the
installation requirements
specified for the hood but, in
any case, the distance between
the hob and the hood must not
be lower than 700 mm.
If the bottom part of the hob is adjacent to an area normally accessible
for handling or cleaning operations, a separator it must be put 0 mm
below the bottom part of the hob.
When installing an oven under the hob, separator must not be put and
the minimum distance between the bottom part of the hob and the
oven must not be lower than 10 mm. Do not install not cooled oven
under this hob and install the oven following its own installation
requirements.
min 10 mm
04 GB
Slot depth: 5 mm
mm
150 mm
700 mm
55 mm
2