Designated Use; Safety; Functional Safety; Obligations Of The Operator - FRIATEC FWSG 63 Bedienungsanleitung

1.2

Designated use

The scraper tool FWSG 63 serves the processing of pipes made of PE 100,
PE 80 and PE-Xa in the dimensions d 20 to d 63 (1/2" IPS to 2" IPS). It is a
precision tool and is suitable to remove the oxide layer as preparation for an
electrofusion joint which forms on the surface of PE pipes during their storage.
The service life depends on the frequency of use and the external influences
during use and/or the storage or transport of the tool.
These operating instructions apply in connection with the FRIALEN Safety
Fittings assembly instructions.
NOTICE
Before any fusion, a scraping has to be performed in any case!
Leaking fusion joints may result if the oxide layer is not removed completely.
2.

Safety

2.1

Functional safety

The scraper tool FWSG 63 is subject to the quality management pursuant to DIN
EN ISO 9001:2008 and is checked for its functional safety before any delivery.
2.2

Obligations of the operator

All persons involved in commissioning, operation, maintenance and repair of the
scraper tool FWSG 63 must:
• be correspondingly qualified, and
• strictly observe these operating instructions.
The operating instructions must always be kept at the place of use of the tool
(transport box recommended). The instructions must be available to the operator
any time.
With regard to the intended use, please observe the accident prevention
regulations, environmental regulations and statutory rules, as well as the relevant
safety regulations and all local standards, laws and regulations.
Downloaded from www.Manualslib.com manuals search engine
EN
13