English; Before Use - Braun TexStyle 9 Gebrauchsanweisung

Partikel und weisse
Verunreinigungen treten
beim Bügeln aus.
Sprühfunktion oder
Dampfstoß funktionieren
nicht richtig.
Die LED Leuchte leuchtet
dauerhaft auf.

English

Before use

Please read instructions carefully and
completely before using the appliance.
Caution: Due to the high power of
this steam iron please make sure
that your mains supply is
sufficient. Please contact your
local electric power company to
make sure that the so called mains
impedance is not higher than
0.198 Ohm.
Description
1 Spray nozzle
2 Water tank lid
3 Spray button
4 Steam regulator
5 Turbo steam button
6 Steam shot trigger
7 Temperature control LED
8 Power cord
9 Heel rest
10 3D soleplate
(A) Start ironing
Filling the water tank
• Make sure that the appliance is switched
off and unplugged.
• Fill the water tank with tap water by
holding the iron slightly inclined, taking
care not to exceed the"max" level. If you
have extremely hard water, we recom-
mend that you use a mixture of 50 % tap
water and 50 % distilled water.
• Attention: Never use distilled water
exclusively. Do not add any additives (e.g.
starch). Do not use condensation water
from a tumble dryer.
Die Dampfkammer des
Bügeleisens ist verkalkt.
Der Wassertank ist leer.
Problem mit dem Temperaturfühler
Entkalken Sie das Gerät
(Dampfkammer und Ventil).
Befüllen Sie den Wassertank.
Ziehen Sie den Stecker und schließen
dann das Gerät wieder an. Wenn das
Problem immer noch auftritt,
kontaktieren Sie den Braun
Kundendienst.
Ironing with steam
• Place the iron on its heel rest (9) and plug in.
• The iron will start to heat up and the
temperature control LED (7) on the iron
will blink.
• Once the temperature has been reached,
the temperature control LED turns
permanently on.
Steam options:
• Continuous steam (normal)
Select the steam quantity by turning the
steam regulator (4) in a range from «1»
to «6». We recommend a medium steam
setting for regular ironing. Only when
ironing tough fabrics like linen, thick
cotton or jeans it is recommended to use
the maximum steam setting.
Note: While ironing, do not turn the steam
regulator beyond setting «6».
• Continuous steam (turbo)
When the steam regulator is positioned
anywhere between «0» and «6» it is
possible to activate the turbo function by
pressing the turbo steam button (5) in
order to emit the highest steam output
and remove stubborn creases.
Press the turbo steam button for not more
than 30 seconds.
• Steam shot
Prior to use, press the steam shot trigger
(6) 3 to 4 times to activate it.
• For a powerful boost of steam, press the
steam shot trigger at intervals of a few
seconds.
• It is possible to use the steam shot
function by holding the iron in a vertical
position and pulling the steam shot
trigger. This is useful for removing creases
from hanging clothes, curtains etc.
Spray function
The spray function (3) produces a fine mist
that evenly moistens the fabric and makes it
easier to iron out creases on very tough
textiles.
9