Disassembly; Trouble Shooting; Repairs - Z-RAY JAVELIN 300 Bedienungsanleitung

MAINTENANCE AND STORAGE
Warning:
Certain household cleaning solvents, chemicals and other liquids (such as battery acid, oil
and petrol) could damage the PVC fabric. In the event of spill or mishandling, you should
check for leaks and inspect for structural integrity.

DISASSEMBLY

1. Remove all the accessories from the boat: fishing rod, oars.
2. Open all valves and deflate the boat completely.
3. Fold the boat (make sure that the boat is clean and dry. See the above Maintenance &
Storage chapter).
4. Put boat and air pump, oars into carry bag for storage.

TROUBLE SHOOTING

When you find the boat appears a bit soft, it might not definitely be because of a leak.
Firstly you can check if valve caps are loose. If all valves are in good condition, you can
consider if it is caused by temperature variation: If the boat was inflated in the day at higher
temperature, say, 35 C (95 F), and air might cool down to 25 C (77 F) overnight, so that the
pressure on the hull may lower down, and the boat will appear soft the next morning.
If valves and temperature variation are not the reasons, you need to start looking for a leak:
1. Position the leak area: You can check your boat from a few feet away or flip it over and
closely check over the outside. Any large leaks should be clearly visible.
2. Pinpoint the location of the leak: spry mild soapy water over the suspicious areas. Any
leak will produce bubbles.
3. Check valves system for leak.
12
Downloaded from www.Manualslib.com
www.zraysports.com ZBV-16-GB(V1)
manuals search engine

REPAIRS

Little holes or puncture can be repaired with the repair kit come along with the boat.
1. Find the leak.
2. Thoroughly clean the area surrounding the leak to remove any dirt or grime.
3. Cut a piece of repair material in round shape, which should be larger than the damaged
area.
4. Using a piece of the repair kit, trace outline of the patch lightly.
5. Apply adhesive to the underneath side of the patch and around the area to be repaired.
Coat the affected are lightly but completely with glue.(not included in the product, please
purchase separately from your market.)
6. Put the patch on the damaged area and press down firmly.
7. Allow 12 hours for repair to dry. After patch has dried, apply glue around the edges for a
complete seal (dry 4 hours).
Limited Warranty Card
We warrant all components contained in this Laminated PVC Boat/Kayak/Stand
up Paddle Board.,etc against defects in materials and workmanship under normal
use and service, for a period of 365days from the date of purchase for the original
owner only.
If any of the components have been consumer-replaced, damaged, or misused,
the corresponding warranty on those components is invalidated. In this situation,
you will be advised of the cost of replacement parts and processing instructions.
If a verifiable manufacturing defect is found during the relevant time period, we
agree to repair or replace at its option any product under warranty provided
proper proof of purchase is presented.
This limited warranty is not valid if the product is used for commercial purposes,
or if the damage is caused by an accident, an act of God, consumer misuse,
neglect or abuse, vandalism, improper use of chemicals, exposure to extreme
weather conditions or negligence during product set up or disassembly.
We cannot be held responsible for the cost of installation, labor, or transportation
expenses incurred due to the replacement of defective parts. This limited
warranty, furthermore, does not cover any unauthorized alterations to the product.
In order to submit a claim, kindly please fill in all the parts of this form and send
it by email or fax, attaching a copy of the receipt, the description of the problem
and two photographs (as explained below, see the step #4). Jilong® is not
responsible for any expenditure on the purchase of chemical products, wasted
water, neither any consequences of water leakage. The warranty is not valid
when defects are not caused by the producer.
13 www.zraysports.com ZBV-16-GB(V1)