Exchange fuse on the 12 V
vehicle-connection
j
R elease (and remove) the knurled ring
turning it against the clockwise direction.
j
R emove the defective fuse and replace it
with a new one, max. 10 amps.
j
S crews the knurled ring
turning it in the clockwise direction
Error tracing
the manometer display
C heck, if the12 V vehicle- connection
inserted completely and correct and voltage
is on. (POWER-LED on 12 V vehicle-connec-
tion
10
C heck, if the POWER-LED on 12 V vehicle-
connection
of the 12 V vehicle-connection
the fuse on the 12 V-socket of the vehicle.
Despite switched on On- / OFF-switch
(in position ) the device does not start
the pumping procedure.
T urn the ignition key / ignition into the first
position (do not start the engine)
the device does not finish the pre-set
pump procedure automatically.
E nsure that you have followed the operating
instructions correctly.
E nsure that you have pre-set the correct
value.
the power cable and / or the 12 V vehicle-
connection gets hot.
D anger of short circuit - Disconnect the
device immediately from the circuit.
the manometer-display
wrong value or is not readable.
E nsure that the device has measured the ac-
tual tyre pressure, (see chapter „Tyre pressure
check").
Downloaded from
www.Manualslib.com
Operation / Error tracing / Maintenance and care / Service / Warranty
again firmly, by
11
does not shine.
2
shines).
shines. If not, check the fuse
10
10
shows the
2
manuals search engine
P ull off the 12 V vehicle- connection
at least 5 seconds from the 12 V-socket of the
vehicle and remove the valve connection
, by
from the vehicle. Wait until the manometer-
11
display
procedure again.
the pump procedure is running, but the
tyre does not inflate.
E nsure that the valve-connection
correctly on the valve of the vehicle.
E nsure that the tyre does not have a puncture.
Maintenance and care
is
10
The device is maintenance-free.
WarnIng!
vices from the power supply, before you carry
as well as
out service etc.
j
S witch off the device .
j
P ull of the 12 V vehicle connection
3
the 12 V-socket of your vehicle.
j
C lean the device with a dry cloth. Do not use
solvents or other aggressive detergents
under any circumstances.
Service
WarnIng!
device to qualified technical personnel to
repair. Thus the safety of the device is guaran-
teed and maintained.
WarnIng!
plug or the connecting cable always to quali-
fied technical personnel. Thus the security of
the equipment is guaranteed and maintained.
Warranty
The general guarantee conditions refer to
production and material defects.
shows 0,0 again. Re-start the
2
Always separate electrical de-
Leave the repair of the
Leave the exchange of the
for
10
15
is fixed
15
from
10
GB
15