Operation
j
C arry out the desired work procedures as
described in following chapters.
j
S witch on the compressor by pressing the
ON-/ OFF switch
j
S witch off the compressor by pressing the
ON-/ OFF switch
j
P ull the 12 V vehicle connection
12 V-socket of the vehicle.
Light switch ON / OFF
The light source on the compressor is intended
to better illuminate the working area (valve)
j
P ress the ON-/OFF –switch Light
position
j
P ress the ON-/OFF –switch Light
position , to switch off the 3 LED
Set the unit of pressure
(psi, bar or kPa)
j
P ress the button Pressure unit „R"
the desired pressure unit is shown on the
manometer display
Tire pressure check
j
U nwind the high-pressure hose
pletely.
note: Make sure that the power LED at the
12 V vehicle connection
manometer display
before beginning of the measurement.
j
F ix the valve connection
the vehicle.
If the valve connection
ed with the vehicle valve, the manometer
display
j
I f this value corresponds to the recommend-
ed tire pressure for the vehicle, you can
remove the valve connection
14
GB
Downloaded from
www.Manualslib.com
into the position .
3
into the position
3
, to switch on the 3 LED
.
2
13
lights up. The
10
must indicate 0,0
2
on the valve of
15
is correctly connect-
15
shows the current tire pressure.
2
15
manuals search engine
Tire pressure increase / decrease
If the indicated value lies under or over the rec-
ommended tire pressure for the vehicle, proceed
for adjustment as follows:
.
j
from the
P ress the button pre-setting „+ "
10
tively the button pre-setting „- "
pre-set value of the manometer display
corresponds to the correct tire pressure.
j
S witch on the compressor by pressing the
ON- /OFF- switch into position . The device
increases respectively decreases the tire
pressure according to the pre-set value and
switches off automatically.
j
into
R emove the valve connection
16
.
14
Important:
into
16
j
.
D uring the pumping procedure do not press
14
the buttons
j
I f you connect the device to the 12 V-supply
of a vehicle but do not start the pumping
procedure, the manometer display
switches off after some minutes. You acti-
until
vate it again, by pressing the button unit of
1
pressure „R "
Use delivered valves
In the stowage box cover
com-
there are 3 typical valve adapters.
Always consider the manual of the object which
is to be pumped up.
·
Racing cycle valve (Presta valve)
·
Valve for sport balls
·
Valve for inflatable toy
j
S crew the desired valve on the valve con-
nection
maximum pressure of the object which is to
be pumped up and read the respective
operating manual.
again.
15
or
.
4
5
.
1
of the compressor
6
8
9
. Consider the corresponding
15
respec-
5
until the
4
2
carefully.
2
7