Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
__________________________________________________________________________________
Note:
There should never be any open or short circuits
amongst the product. Check to ensure that the
system design documentation reflects the
installation and any changes that have occurred.
Regarding temperature, the products are
manufactured out of special materials with high
demands to chemical and mechanical stability,
which also applies to the power supply cables.
Repairs:
Repairs may be made only by authorized staff
by origin manufacturer or by enterprises
expressly authorized by this manufacturer.
When returned, please always confirm
decontamination status in written form and
support this information directly with the
returned product.
If a decontamination form is required, then
please get in contact with us, where we will
support you.
Malfunction and Excessive Strain
If it has been assumed that safe operation is
no longer possible, the installation must be
permanently shut down and secured against
being inadvertently put back into operation.
This is the case, if...
... the product shows visible signs of damages
... the product is not operating according to
specification
... the product is not operating at all (no
visible indication of reason)
... the product has been exposed to excessive
strain
... the admissible product limits are exceeded
(e.g. storage, transportation, operating
temperature)
Heated Media
The product must not be used to heat explosive
media or media developing explosive gases
when heated. The product must only be
installed outside hazardous locations. When
setting the temperature of the control and, if
applicable, of the limiter, the properties of the
medium to be heated have to be observed!
Attention!
During operation, the product can develop
temperatures, which may lead to burning when
touched. Therefore suitable personal protection
measures have to be taken into consideration.
When switched on, the product must not be
touched.
Environmental information for
industrial customers within the
European Union
To
demand
of
the
2002/95/EC and of the national Product Safety
Act, equipment that is equipped with this
symbol directly provided on or with the product
and / or its packaging must not be disposed of
together with unsorted municipal waste. The
symbol indicates that the product should be
disposed of separately to regular industrial
/domestic waste.
It is your responsibility to use this product and
other electrical and electronic products only on
the legally prescribed methods of disposal or the
competent and of the government or local
authorities defined collection points for disposal.
Correct disposal and recycling will help prevent
potential negative consequences for the
environment and human health.
If you need further information about disposal
of your old equipment, please contact the local
authorities, waste disposal service or the dealer
from whom you purchased the product.
European Directive
9 |
P a g e - S e i t e
Werbung
Inhaltsverzeichnis
