Before Use - Braun TexStyle 7 Pro Handbuch

Sprühfunktion oder
Dampfstoß funktionieren
nicht richtig.
Die Bügelsohle wird nicht
heiß
English

Before use

Please read instructions carefully and
completely before using the appliance.
Description
1 Spray nozzle
2 Water tank lid
3 Spray button
4 Steam regulator
5 Turbo steam button
6 Steam shot trigger
7 Temperature selector
8 Temperature control LED
9 Power cord
10 Heel rest
11 3D soleplate
(A) Start ironing
Filling the water tank
• Make sure that the appliance is switched
off and unplugged.
• Fill the water tank with tap water by
holding the iron slightly inclined, taking
care not to exceed the "max" level. If you
have extremely hard water, we recom-
mend that you use a mixture of 50 % tap
water and 50 % distilled water.
• Attention: Never use distilled water
exclusively. Do not add any additives (e.g.
starch). Do not use condensation water
from a tumble dryer.
Ironing with steam
• Place the iron on its heel rest (10) and
plug in.
• Select a temperature (7) which is suitable
for the garments (refer to the garment
guide on the heel rest). The iron starts to
heat up and the temperature control LED
(8) on the iron is on. The anti-drip function
is automatically activated to prevent
water leakage at low temperature
settings.
• Once the selected temperature is
reached, the temperature control LED
turns off.
Steam options:
• Continuous steam (normal)
Der Wassertank ist leer. Befüllen Sie den Wassertank.
Ziehen Sie den Stecker des
Bügeleisens heraus und stecken
Sie ihn wieder in die Steckdose.
Drehen Sie den Temperaturregler
von „min" auf „max". Wählen Sie
dann die gewünschte Temperatur
aus.
Select the steam quantity by turning the
steam regulator (4) in a range from «1»
to «6». We recommend a medium steam
setting for regular ironing. Only when
ironing tough fabrics like linen, thick
cotton or jeans it is recommended to use
the maximum steam setting
Note: While ironing, do not turn the steam
regulator beyond setting «6».
• Continuous steam (turbo)
When the steam regulator is positioned
anywhere between «0» and «6» it is
possible to activate the turbo function by
pressing the turbo steam button (5) in
order to emit the highest steam output
and remove stubborn creases. Press the
turbo steam button for not more than
1 minute.
• Steam shot
Prior to use, press the steam shot trigger
(6) 3 to 4 times to activate it.
For a powerful boost of steam, press the
steam shot trigger at intervals of a few
seconds.
The temperature selector should have a
minimum temperature level 3 (•••).
It is possible to use the steam shot
function by holding the iron in a vertical
position and pulling the steam shot
trigger. This is useful for removing creases
from hanging clothes, curtains etc.
Spray function
The spray function (3) produces a fine mist
that evenly moistens the fabric and makes it
easier to iron out creases on very tough
textiles.
Dry ironing
Set the steam regulator (4) on position «0»
(= steam off).
(B) Auto off
For safety and reduced power consump-
tion, the auto-off function is automatically
activated when the iron is positioned
horizontally on its soleplate for about
30 seconds or vertically on its heel rest for
about 8 minutes.
9