Herunterladen Diese Seite drucken

HEINE mPack mini Gebrauchsanweisung

Ladebatterie
Vorschau ausblenden Andere Handbücher für mPack mini:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

HEINE
mPack mini
®

Werbung

loading

Inhaltszusammenfassung für HEINE mPack mini

  • Seite 1 HEINE mPack mini ®...
  • Seite 2 HEINE mPack mini ® DEUTSCH ENGLISH FRANÇAIS ESPAÑOL ITALIANO SVENSKA NEDERLANDS DANSK NORSK SUOMI PORTUGUÊS MED 113158 2017-01-18...
  • Seite 3: Installation

    Laden Sie den HEINE ® Laden Verbinden Sie den USB-Anschluss (1) des mPack mini mit Hilfe eines USB-Kabels mit einer USB-Stromversorgung (z. B. HEINE E4-USB, PC oder Laptop). Zu Beginn des Ladevorgangs leuchten kurz alle drei Leuchtsegmente der Betriebsanzeige (4) auf.
  • Seite 4 Reinigen und desinfizieren Sie den mPack mini durch Wischen. An exponierten Stellen wie z. B. den Bedienelementen muss eine besonders gründliche Reinigung und Desinfektion durchgeführt werden. Halten Sie den mPack mini bei der Aufbereitung mit den jeweiligen Öffnungen nach unten. Empfohlene Mittel Reinigungsmittel: enzymatisch (z. B. neodisher MediClean) ®...
  • Seite 5 Allgemeine Hinweise Die Garantie für das gesamte Produkt erlischt bzw. gilt auch nicht, bei Verwendung von nicht originalen HEINE Produkten, nicht originalen Ersatzteilen, und wenn Ein- griffe (insbesondere Reparaturen oder Modifikationen) von Personen vorgenommen wurden, die nicht von HEINE autorisiert sind. Nähere Informationen hierzu erhalten Sie unter www.heine.com.
  • Seite 6 ® Charging Use a USB cable to connect the USB connector (1) of the mPack mini to a USB power supply (e.g. HEINE E4-USB, PC or Laptop). At the start of the charging process, all three illuminating segments of the status indicator (4) light up briefly. During the charging process, the segments light up progressively to indicate the charging status.
  • Seite 7 The connected instrument cannot be operated during the charging process! The illumination of the instrument is switched off as soon as the mPack mini is connected to a USB power source. Once the charging connection is disconnected, the instrument illumination is switched on again at the previously set brightness level.
  • Seite 8 General Notes The warranty for the entire product is invalidated if non-genuine HEINE products or non-original parts are used and if repairs or modifications are made to the device by persons not authorized by HEINE. For more information, please visit www.heine.com.