Switching On/Off - EWT MULTIPRO Benutzerhandbuch

CHARACTERISTICS
MODEL
Ventilator
Heating
Air purifier
Air cooler
Air freshener
Ionisation function
Heating power
Ventilation power
Thermostat
Water tank capacity
Number of temperature choice
Number of ventilation speeds
Oscillation
Tilting
Timer
Filters
Filter clean indicator
Cooling blocks
Remote control
360° pivoting wheels with brakes on front
Voltage
Frequency
Product dimensions (LxDxH)
Product weight
BEFORE USING THE APPLIANCE FOR THE FIRST TIME
1. Please read these instructions carefully before using
the appliance and keep them in case of future use.
2. Make sure that the voltage of your local electricity
network corresponds to the one which appears on the
appliance.
3. B efore using it for the first time, remove the appliance's
protective tabs and stickers.
4. Ensure that the switch on the side is in the "OFF"
position.

SWITCHING ON/OFF

PLUGGING IN AND SWITCHING ON
Before plugging the appliance in, please read
the "Safety Instructions" and "Warnings"
paragraphs carefully. To switch the appliance
on, press the ON/OFF SAFETY button located
on the side of the appliance. Once this button
has been switched to on, the appliance will go onto standby
14
MULTIPRO
Yes
Yes
Yes
Yes
Yes
Yes – filters more than
99% of particles in the air
2000W
70W
Electronic
5.5L
3: 22°C, 29°C, 36°C
3
Yes, automatic
Yes, automatic
1-2-4-8H
3 : Anti-dust filter/H 0
2
filter for cooler air/
Foam filter for air
freshener function
Yes
x 2
Yes, with remote
control housing
Yes
220 - 240V~
50Hz
25 x 33 x 70cm
10kg
mode, two audible "bleeps" will be emitted and the power
light will flash for two seconds.
SWITCHING ON
Having pressed the power button on the side of
the appliance, press the "ON/OFF" button on the
control panel to switch the appliance on. It will
emit a single audible "bleep".
SWITCHING OFF
Press the "ON /OFF" button again to set the appliance to
standby mode when it is operating.
In ventilation mode, pressing this button allows you to set
the appliance to standby mode.
In heating mode, the radiator will stop working after 10
seconds as a safety measure and then the entirety of the
system will be deactivated.In order to switch the appliance
off completely, press the big "ON/OFF" button located on the
side of the product.
ENERGY-SAVING NIGHT LIGHTING MODE
If there is no activity for more than a minute, the intensity of
the light emitted by the indicators will fall by 33%.
COOLER
TANK FILLING
WARNING: Do not place anything in the
separation compartment such as the cooling
blocks. This allows the pump to drop into the
water tank (see photo). If not, there is a risk of the tank
becoming blocked.
Water tank Water tank
locked unlocked
(Fig.1) (Fig.2)
In order to use the appliance in cold mode, remove the water
tank by turning the lock located at the back and on the base
of the appliance.
Before pouring water into the tank, turn the locking system
through 90° (Fig.2) in order to remove the water tank (Fig.3).
When pouring the water, (Fig.4), pay careful attention to the
level in the tank, which must not be below the "MIN" level
marker or above the "MAX" level marker. Carefully replace the
tank into the appliance and turn the locking system (Fig.1) to
block the tank in. Check that the water is clean.
It is normal for the appliance to emit an odour the first time
you use it.
FR EN
Remove Put water into
water tank the water tank
(Fig.3) (Fig.4)
DE