Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Bending procedure for JRG Sanipex MT pipes d26 – d63
Mark the centre of the bend onto the
pipe.
min. 1 cm
Insert the pipe into the bending tool.
Pay attention regarding the centre
of the bend and that the pipe has to
stand out of the bending rolls.
Attention
When the start button is released, the bending process is
immediately aborted. The process can be continued and terminated
by renewed pushing and holding of the start button.
16
1/6
min. 1 cm
1
Define the bending angle and
secure it with the fixing screw.
3
Push the start button on the
bending tool and hold it pushed.
The bending tool automatically
terminates the bending process
when the bending angle adjusted
has been reached.
2
4
Werbung
