PRASTEL TCO7RX Handbuch Seite 10

5. LEARNING
5.1 Learning of the transmitters on the first relay of the receiver
Check that the DIP 3 and 4 of the transmitter
1
and of the receiver are set in the same way.
Press and keep pressed the key present on
2
the receiver.
3
Release the key on the receiver.
Press and keep pressed the key present on
4
the transmitter.
5
Release the key of the transmitter
For the successive learning, repeat the operation from point 1.
5.2 Learning of the transmitter on the second relay of the receiver
Check that the DIP 3 and 4 of the
1
transmitter and of the receiver are set in the
same way.
Press and keep pressed the key present on
2
the receiver.
DO NOT release the key on the receiver.
3
Release the key on the receiver.
4
Press and keep pressed the key present on
5
the transmitter.
6
Release the key of the transmitter
NOTE: in case in which instead 4 BIP are reproduced, it means that the maximum number of transmitters for the selected channel has been
reached and that no new devices on the same relay can be memorized.
In case in which a device previously memorized is then associated to the other relay, it will be automatically removed from the previous relay.
For example, if a device memorized on the relay 1 is memorized on the relay 2 it will be automatically removed from the relay 1.
5.3 Summary of the acoustic signalling during the learning phase
Number of BIP
2
4
1
6. SELECTION OF THE TYPE OF SIGNAL ON OUTPUT RELAY
Beside the two receiver relays a jumper for the selection of the type signal to give on output is present. This signal can be:
1. A clean contact : open contact in case of alarm and close if the alarm is not present
2. A contact type 8,2K : resistance of the contact = 0 or ∞ (Open loop) Ohm in case of alarm and 8,2KΩ if the alarm is not present. The control
unit connected to the device must be able to handle this type of signal.
The selection of the type of signal is carried out in the following way:
MEC.
Jumper Pos. 1
The receiver emits 1 bip
The receiver emits 2 bips.
The learning ended correctly.
The receiver emits 1 bip
The receiver emits 2 bips.
The receiver emits 2 bips.
The learning ended correctly.
Acoustic signalling during the learning phase
Transmitter correctly memorized
Mistake : the maximum number of transmitter for selected channel has been reached
Maximum time up for the memorization of the transmitter (10 second)
Position 1 : clean contact functioning (Mec)
8K2
Position 2 : 8K2 functioning (8,2K)
Jumper Pos. 2
FRA ENG ITA
Meaning
ESP DEU POR
4 / 6