Maintenance And Cleaning; Repair & Maintenance; Environmental Protection - Concept Rk2180 Bedienungsanleitung

6. Remove the kettle from the base and use water.
7. I f you want to reheat water you have just finished boiling, wait approximately 30
seconds before activating the switch.
8. A ny impurities are caught by the filter while pouring.
Note: If a few drops of water appear at the base after use, it is not a defect. It is
a small amount of condensed steam, which deactivates the kettle thermostat.

MAINTENANCE AND CLEANING

WARNING!
Before cleaning the unit, always disconnect the power cord from the wall outlet!
Prior to handling, make sure the unit has cooled down!
The surface of the unit may only be cleaned using a wet cloth. Do not use any detergents
or hard objects as they may damage the unit's surface!
Never clean the unit under running water, do not rinse it, and do not submerge
it in water!
REMOVAL OF BOILER SCALE
Impurities from water collect during normal use. These sediments can be removed
from the kettle perfectly by using preparations designed for removing limescale (see
the producer's instructions), or using the following procedure:
1. Pour three cups of vinegar into the kettle and top up with water. Leave the solution
in the kettle overnight. Do not boil!
2. Pour out the contents, and clean remaining sediment using a wet cloth. Top up the
kettle with clean water, boil it and pour out again. Repeat the procedure. The kettle
is then ready for operation.
Note: Remove the sediment inside the kettle regularly, at least once a week, depending
on the water hardness and frequency of use. Deposits reduce the heating effect and
life of the kettle considerably.
REPAIR & MAINTENANCE
Any extensive maintenance or repair that requires access to the inner parts of the product must be performed by an expert
service centre.

ENVIRONMENTAL PROTECTION

• Packaging materials and obsolete appliances should be recycled.
• The transport box may be disposed of as sorted waste.
• Polyethylene bags shall be handed over for recycling.
Appliance recycling at the end of its service life:
A symbol on the product or its packaging indicates that this product should not go into household waste.
It must be taken to the collection point of an electric and electronic equipment recycling facility. By making
sure this product is disposed of properly, you will help prevent the negative effects on the environment
and human health that would otherwise result from inappropriate disposal of this product. You can learn
more about recycling this product from your local authorities, a household waste disposal service or in the shop where
you bought this product.
24
EN
Fig. 2
RK2180