Videos - NUK Eco Smart Control 300 Bedienungsanleitung

Formatting the SD card:
1. Press here to format the SD card inserted
into the camera.
A new menu will appear:
2. Press "Format SD card".
A new screen will appear:
3. Press "Next".
The SD card will now be formatted. Any
data on the card will be deleted.
Device information:
No settings can be changed here, there is
only information on the app in question.
Once an SD card is inserted into the
camera, the total and free capacity will be
shown.
The camera is able to record live images. A
MicroSD card must be inserted for this
purpose (not included in this pack).
1. Push the MicroSD card into the slot for
the MicroSD card 2.
Notes:
– The SD card slot is designed in such a
way that there is only one correct way
to insert the SD card.
6.4 Notification (Push
Notification)
If the function Noise Detection (see "Noise
detection:" on page 30) or Motion Detection
(siehe „Motion detection:" auf Seite 30) is
activated, a message or notification will be
sent by the notification centre of the iOS
system (Push Notification) once sound or
movement is picked up.
Further information on the iOS notification
centre and the associated settings can be
found in the documentation included with
your smartphone or tablet.
6.5 Changing the connection
Once the camera is correctly registered to
the smartphone, the NUK LiveCam will
automatically
convenient connection:
If the smartphone is located within the
coverage area of the WLAN router to which
it was registered, this connection will be
chosen.
If you are not within range of the WLAN
router and have registered to a WiFi access
point, this connection will be chosen.
If there is no WiFi network available, the app
will use the Internet to connect to the
camera. Your smartphone must be able to
connect to the Internet quick enough for this
to be possible (3G/UMTS required at a
minimum). Please note here that the
transmission quality may be restricted and
you may incur costs from your provider if
you do not have a sufficient flat rate.

7. Videos

– Push the SD card far enough into the
slot 2 that it clicks into place and
disappears completely into the camera
housing.
2. Start the camera again by pulling out the
plug for the camera cable and then
establishing the connection again.
3. Format the SD card (see "Formatting the
SD card:" on page 31).
31
search for the most