NUK Eco Smart Control 300 Bedienungsanleitung Seite 28

Notes:
• Always connect
inserting the Powerline adapter into the
socket.
• Multiple socket outlets with overheating
cutout may not be used. These block the
signal.
• The camera and Powerline adapter must
be connected to related phases. This will
generally be the case when both plug
sockets are connected to the same
electricity meter.
5.3 Preparing the
smartphone/tablet
1. Connect your smartphone/tablet to your
wireless network. Further information on
connecting to a wireless network can be
found in the instructions for your iPhone/
iPod/iPad.
2. If you do not have the app for reading QR
codes on your smartphone:
– Connect to the App Store.
– Download and install the app for
reading QR codes, e.g. "Barcode
Scanner".
3. Download the free app "NUK LiveCam"
from the App Store.
4. Start the NUK LiveCam App.
5. Press "Add Camera".
6. Activate the camera. To do this, there are
three options:
Option 1:
– Press "QR code";
the cables before
– Scan the QR code (UIC code) on the
reverse side of the camera.
– Enter the password. The factory-set
password is 888888.
– Press "SAVE".
Option 2 (only works if the smartphone is
connected to the same wireless network
as the Powerline adapter):
– While the app is starting, there will be a
search for any cameras already on the
network. Any cameras found will be
shown in a list.
– Select the camera by tapping the
corresponding row.
– Enter the password. The factory-set
password is 888888.
– Press "SAVE".
Option 3 (manual entry):
– Press "Add".
– Enter a name for the camera.
– Manually enter the UID number of the
required camera. This can be found on
the reverse of the camera.
– Enter the password. The factory-set
password is 888888.
– Press "SAVE".
Note: For security reasons, you should
immediately change the password to
protect your
settings:" on page 29).
26
data (see "Password