NUK Eco Smart Control 300 Bedienungsanleitung Seite 32

Video settings:
Video quality:
compression are set here. The setting here
is generally "maximum". A lower setting
should only be selected if the data
connection is slower.
Video Flip: Here, you can choose to film a
video.
Environment Mode: The camera can be
adapted to the lighting conditions:
– Indoor (50 Hz): For artificial lighting
conditions with
network.
– Indoor (60 Hz): For artificial lighting
conditions with
network.
– Outside: For natural lighting.
– Night: No light. The infrared function
on the camera is used here.
Time zone:
Here, you can select the time zone
applicable to you.
The time shown in the camera image will be
transmitted by the network. This is the GMT
time zone. UK is located in Zone +0 during
the winter and Zone +1 in the summer.
Noise detection:
Sound detection: Here, you can set the
sensitivity of the noise detection setting, i.e.
at what noise level the camera should be
automatically activated
message/notification to the smartphone.
Resolution and
a 50 Hz power
a 60 Hz power
and send
Note: This noise level has no influence on
the volume of the live view. The volume
must be managed from your smartphone
or tablet.
Triggering: Here, you can set the length of
time a noise must be audible before it
automatically activates the camera and
sends a
data
smartphone.
Motion detection:
The camera is not only activated by noises,
but also movements that are within view.
Here, you can set the sensitivity of the
motion detection setting, i.e. what kind of
movement will automatically activate the
camera and send a message/notification to
the smartphone.
Recording settings:
The camera is equipped for the use of a
Micro SD card (see "7. Videos" on page 31),
with which it can record videos.
Recording Mode: Here, you can decide
whether you wish to record a video always
(Always), never (Off) or only if a noise or
movement is detected (Alarm).
If the "Alarm" mode is set, any noise or
movement made will be recorded. At the
end of the recording, a notification will be
sent to the smartphone (tablet) and you can
view the video (see...)(see "6.2 Functions of
the start screen, closing the app" on
page 28)
In the "Alarm" mode, the image will be
recorded continuously. However, only the
last minute is ever saved when a noise or
movement
notification
smartphone.
Recording resumes for every new alarm.
a
30
message/notification
is detected. A
is then send
to the
message/
to your