Electrical Connection; Installation And Start-Up; Ambient Temperature - Nordcap WG 155 Aufbauanleitung

GB Reserving the right to alter specifications without prior notice.
9193215 rev 06

Electrical connection

Wiring and connections in power supply
systems must been all applicable (local and
national) electrical codes. Consult these
codes lengths and sizes prior to cabinet
installation.
This device complies with relevant EU
directives including Low Voltage Directive
2014/35/EU and Electromagnetic Compatibil-
ity Directive 2014/30/EU
The socket should be freely accessible.
Connect the appliance only to 220/240 V
/ 50Hz alternating current via a correctly
installed earthed socket.
The socket must be fused with a 10-13 A
fuse.
If the appliance is to be operated in a non-
European country, check on the rating plate
whether the indicated voltage and current
type correspond to the values of your mains
supply.
Information regarding voltage, current or
power are given on the rating plate
The power cord may be replaced by a tech-
nician only.
The rating plate provides various techni-
cal information as well as type and serial
number.

Installation and start-up

Placement
For safety and operational reasons, the ap-
pliance must not be installed outdoors.
The appliance should be placed on a level
surface in a dry, well ventilated room (max.
75% relative air humidity). Never place the
appliance clo se to sources of heat such as
cookers or radiators, and avoid placing it in
direct sunlight.

Ambient temperature

The climate class is stated on the name
plate. This specifies the optimum ambient
temperature. Wine coolers with winter posi-
tion, however, function at ambient tempera-
tures as low as 5ºC.
Climate class
SN
N
ST
T
fig.2
2
Optimum room
temperature
+10 ºC to +32 ºC
+16 ºC to +32 ºC
+18 ºC to +38 ºC
+18 ºC to +43 ºC