Library Mode - NAD HTR 2 Bedienungsanleitung

Downloaded from www.Manualslib.com
LEARNING CODES FROM OTHER REMOTES
Begin by positioning the HTR 2 "nose-to-nose" with the source remote so
the two devices' infrared windows are about 2 inches apart.
• Enter Learning Mode: On the HTR 2, simultaneously press-and-hold for
3 seconds both a Device Selector key and the [•] "record" key (just
below the [DISP] key), until the Learn LED at the center of the HTR 2
turns steady green.
• Press the HTR 2's Control key you wish to teach a command; the Learn
LED will turn amber.
• Press-and-hold the control function key on the source remote: The HTR
2's Learn LED will flicker amber for a second or two, then turn solid
green. The command is learned. Repeat this process for all commands
you wish to learn under the selected Device Selector key.
• Press the HTR 2's Device Selector key again to exit the learning mode
after you have completed learning all commands for that Device.
NOTE
If the Learn LED does not flicker amber you may need to vary the
distance between the remotes or try fresh batteries in both remotes. If
the Learn LED turns red rather than green, that particular command of
that source remote command has not been learned. Try again. In rare
instances there may be some IR format that is not compatible with the
HTR 2.
CANCEL OPERATION
You can cancel configuring a key, by pressing the active Device Selector key
before the learn is complete; the Learn LED will turn red.
Example: Learning "DVD Pause":
• Position the HTR 2 and your DVD player's remote as described above.
• On the HTR 2, simultaneously press-and-hold [DVD] and [•]; the Learn
LED turns steady green.
• Press the HTR 2's [ || ] (pause) key; the Learn LED turns amber.
• Press-and-hold the DVD player's remote's pause key; the HTR 2's Learn
LED flickers amber and then turns solid green. The command is learned.
• Press [DVD] again to exit the learning mode.

LIBRARY MODE

To enter the library mode, press and hold a device selector key and the
Preset key for 3 seconds until the status LED turns green. While in Library
mode you can cycle through and test the different pre-programmed tables
in the remote to find if there is an appropriate table for your device. The
several ways of navigating the Library tables are described below. The Learn
LED will flash twice when all available tables have been transmitted.
DIGIT KEYS
The digit keys (0 - 9) can be used to directly select one of the tables. Enter
the 3 digit table number. After pressing the third digit the HTR 2 will
automatically transmit the Power Off command as a test to be sure you
have selected the correct table.
manuals search engine