Datamax W-6208 Handbuch Seite 38

Fan-Fold Media
1. Place an empty media core onto the media supply hub.
2. Install the fan-fold tensioner.
3. Route the media through the rear or bottom fan-fold media slot,
continue to guide the media under the fan-fold tensioner and over
media supply hub.
4. Route the media under the media bouncer, up through a narrow slot
located underneath the printhead area, (ensure that the media passes
through the media edge sensor), and over the platen roller. Continue to
pull until approximately 4-inches of media are visible from the front of
the printer.
5. Slide the media edge guide against the edge of the media.
6. Lower and latch the printhead.
7. Press the feed button several times to ensure proper tracking.
26