Datamax W-6208 Handbuch Seite 37

Media Loading
Printhead Latch
Media Supply Hub
Roll Media
Platen Roller
Media Bouncer
Media Edge Guide
Open the cover. Unlatch and raise the printhead.
Rolled Media
Slide a roll of media onto the media supply hub. Push the media all the
way back until it stops, (it will be resting against the printer's centerplate).
1. Route the media under the media bouncer, up through a narrow slot
located underneath the printhead area, (ensure that the media passes
through the media edge sensor), and over the platen roller. Continue to
pull until approximately 4-inches of media are visable from the front of
the printer.
2. Slide the media edge guide against the edge of the media.
3. Lower and latch the printhead.
4. Press the feed button several times to ensure proper tracking.
5. Close the cover.
Fan-Fold Tensioner
Rear Fan-Fold Media Slot
Bottom Fan-Fold Media Slot
Empty Media Core
Media Edge Sensor
25