Blaupunkt ASF501 Bedienungsanleitung Seite 7

ASF501
1. Front guard
2. Blade nut
3. Fan blade
4. Back guard fixing nut
5. Back guard
6. Motor shaft stem
7. Motor housing
APPLIANCE ASSEMBLY AND DISASSEMBLY
1. Make sure the appliance is disconnected from the power source.
2. Assembly:
a) Arrange the fan feet (15) on a flat surface so that they form a cross base
b) Place the fan stand (11) on the cross base (15) and fasten it with screws (14)
c) Install the cap (13) of the fan base screws on the stand, so that it covers the screws
d) Adjust the height of the stand (11) and screw in the locking screw (12)
e) Mount the motor housing (7) on the fan stand (11)
f ) Install the back guard (5) on the motor body (pay attention to the notches).
g) Install the back guard mounting nut (4).
h) Install the fan blade (3) paying attention to the notches in the stem (6) and in the blade centre
opening.
i) Tighten the the blade fixing nut (2)
j) Install the front guard (1) by fitting its edge into the catches on the back guard. Then, secure it by
tightening the guard fixing screw (9).
3. Disassembly:
a) Perform the disassembly in the reverse order of the assembly procedure.
FAN OPERATION
1. Before connecting the fan to the power supply, make sure that the button on the control panel is set
to 0. Connect the appliance to the power supply.
2. To start the fan, press one of the buttons on the control panel:
1 - low speed
2 - medium speed
3 - high speed
3. To turn off the fan, press the 0 button on the control panel.
4. Oscillation. To enable the fan's oscillation movement, press the oscillation lock. To disable the fan's
oscillation movement, lift the oscillation lock.
5. Vertical tilt adjustment. To change the fan tilt, hold the appliance in position and tilt the motor body.
CLEANING AND MAINTENANCE
Before cleaning and maintenance, make sure that the fan has been disconnected from the power
source.
The fan should be cleaned regularly. Body, posture should be wiped with a dry cloth. The interior
should be blown out with compressed air or vacuumed with a vacuum cleaner.
8. Oscillation lock
9. Guard fixing screw
10. Control panel with push buttons
11. Telescopic fan stand
12. Fan stand's height locking screw
13. Fan base screw cap
14. Fan foot mounting screws
15. Fan feet
5