Pioneer SC-LX78-S Kurzanleitung Seite 6

3
Turn on the power of the AV receiver.
ON
4
Check that on the top of the unit the POWER lamp lights and WLAN
lamp flashes.
When the lamp lights, wait for about 2 minutes and then proceed to the next step.
Lit
Flashes
Connecting to the Wireless LAN Router
1
Press the WPS button on the wireless LAN router.
For details of how to use the WPS button, refer to the instruction manual of your wireless
LAN router.
2
Hold down the Reset/WPS button on the side of the unit for 5 to 10
seconds. The WLAN lamp on top of the unit will light when the button
is released.
Press for 5 to 10 seconds.
Side
6
AV receiver
The WLAN lamp switches from
flashing to lighted.
Top
Connecting to a Wireless LAN Router (WPS button version) (continued)
3
Check that the WLAN lamp on the top of the unit changes from lit to
flashing. The flashing of the lamp means a wireless LAN connection has
been established.
* If the WLAN lamp does not light, press the Reset/WPS button again.
After the WLAN lamp begins
flashing, wait for about 2 minutes,
then proceed to step 4.
4
In order to set up the unit properly, remove the USB feeder cable side of
the supplied cable connected to the unit.
Connection to the wireless LAN router is completed. Now proceed
STEP 3
to .
AV receiver
LAN ( 10/100 )
DC OUTPUT
for WIRELESS LAN
(
OUTPUT 5 V
0.6 A MAX )