Setting The Remote Control; Automatically Setting The Remote Control - Philips SRU1060 Bedienungsanleitung

SRU1060_A6.qxd6
6 ENGLISH

Setting the remote control

This is only necessary if your brand does not respond to the SRU1060.
If that is the case, the SRU1060 does not recognize the brand and/or
model of your brand and you need to program the remote control to do
so.
The example below (TV) instructs you how to do this.
You can repeat the same steps when setting the SRU1060 for your
DVD player/recorder.
You can set the remote control either automatically or manually.

Automatically setting the remote control

The remote control will now automatically search for the right code for
your brand.
Example of TV:
The keys between brackets are used for setting the SRU1060 for your
DVD player/recorder.
1
•
2
3
Downloaded from www.Manualslib.com
25-08-2005
Make sure the TV is switched on and select a channel using the
original remote control or the keys on the TV
(for example channel 1).The SRU1060 emits the 'switch off TV' signal
for all models of TV that are stored in the memory.
If the device is a DVD player/recorder, insert a disk and start playback.
Then keep keys VOL + and PROG +
(5 and 6) on the SRU1060 pressed
simultaneously for three seconds, until the
LED flashes twice and then remains lit.
Press and hold the TV (DVD) key of
the SRU1060.
manuals search engine
12:03 Pagina 6