Maintenance; Repair; Spare Parts - Sky SYSTEM 3 Betriebshandbuch

13) S-fold the canopy into the CONTAINER, leaving a small
space for the lines to be coiled.
14) Close the rear flap and the two lateral flaps.
15) Coil the lines into the space previously left for them, leaving
about 0.5 to 1m length of lines for the outer coils. NEW RINGS
SHOULD BE USED FOR EACH PACKING.
16) Close the fourth flap and insert a coil of lines (about 4 cm)
through the elasticated loop in order to hold the CONTAINER
closed.
17) Coil the remainder of the lines on the outside of the
CONTAINER.
18) VERIFY that you have in your possession all of the items
listed in step 1, as confirmation that no objects have been left
inside the folded parachute.
SKY SYSTEM 3
User manual / Handbuch

10. MAINTENANCE

The canopy is to be stored in clean and dry area. Avoid
prolonged exposure to direct sunlight. If it gets wet, dry the
canopy and lines thoroughly and immediately to prevent
damage caused by mould. Contamination by oils, or any other
chemicals could significantly reduce the load stability of the life-
saving system. The manufacturer must inspect contaminated
canopies. The outer container can be cleaned (WITHOUT the
canopy inside!) using water and a mild detergent followed by a
thorough rinse and drying. Use only clean water without soap
to clean the canopy and lines.
11. REP AIR
All the repairs must be carried by the manufacturer. Any
unqualified repair might lead to a system failure.
12. SP ARE P ARTS
Your Sky System 3 reserve parachute consists of many high-
quality, long-life components. When replacing parts (lines,
risers, fabric panels, etc.), only original parts should be used.
In addition to the continued airworthiness of your reserve
parachute, this is important for your safety as well.
10