Using The Product - nedis DCAM40BK Bedienungsanleitung

2. Place suction fix A
3. Use the suction fix clip A
4. Insert a microSD card (not included) into the microSD card slot A
5. Adjust the position of the front camera A
6. Adjust the position of the cabin camera A
4
Ensure the product and the power cable are installed and do not interfere
with the sight of the driver or impede with the operation of any driving
controls.
4
Always focus your attention on the road.
Connecting the product to a power source
Option 1:
1. Plug the other end of the auxiliary power plug A
3
A
.
9
2. Plug A
into an auxiliary power outlet.
Option 2:
1. Charge the product using the USB port A
4
The product automatically switches on and starts recording when you switch
on your car engine.
4
The recording time can be set in the menu with the range of 3, 5 or 10
minutes.
4
The camera switches off after the engine is off.

Using the product

1. Press power button A
4
When switching off the product automatically saves the recordings.
Menu
1. Press menu / mode button A
y
2. Press A
again to select the desired option.
u
3. Press up A
o
4. Press OK A
y
5. Press A
to exit the menu.
4
In case of first use: set the correct time and date using the menu settings.
While in standby mode:
y
Press A
to toggle between video, photo, and playback mode and menu
settings.
2
on the windshield.
1
to fix the product to the windshield.
t
for 3 seconds to switch the product on or off.
y
i
or down A
to navigate through the menu.
to confirm a selection.
5
for optimal view of the road.
w
for optimal view of the inside.
9
2
.
to enter the menu.
8
4
.
into the micro USB port