Operating The Appliance - KLARBACH VT 36001 ch Gebrauchs- Und Montageanweisung

Installation steps
1. Attach rear grille (4) to motor
housing (6) using four screws.
2. Push fan vanes (2) onto motor
shaft (5) and tighten mounting
screw (14).
3. Centre front grille (1) by aligning
the "Klarbach" logo on the hub so
that it is horizontal and parallel
to the floor.
4. Connect front and rear grilles (1,
4) by snapping the clips
together.
5. Tighten mounting screw (15) of
the front grille on the underside
of the rear grille.
6. Unscrew retaining ring (12) and
locking screw (13) from pedestal
foot (11).
7. Push pedestal tube (10) through
the hole in the middle of the
stand.
8. Turn the pedestal foot base
upside down
9. Secure the the pedestal foot with
retaining ring (12) and locking
screw (13).
10. Finally attach the assembled fan
head with the connecting screw
and mounting nut (9) to
telescopic rod (10).
11. Ensure that the connection is
securely tightened.
Setting up the appliance
• Set up the appliance at a
distance of at least 50 cm from
other objects (curtains, walls,
spray cans).
• Place the appliance on a firm,
level surface.
Electrical connection
RISK OF ELECTRIC
SHOCK!
• A faulty electrical installation or
excessively high mains voltages
can result in electric shocks!
• Connect the fan to a properly
installed plug socket with
earthing contact only when the
mains power supply voltage of
the plug socket corresponds to
the data on the type plate.
RISK OF ELECTRIC
SHOCK!
Water must never be allowed to
enter the appliance.
Do not touch the appliance with wet
hands.

9 Operating the appliance

APPLIANCE DAMAGE!
Improper handling can result in
damage to the appliance.
Switching on the fan
Check before using for the first time
that the mains power supply
corresponds to the voltage indicated
on the appliance type plate.
Switch on the fan with ON/OFF knob
"7".
EN
Page | 19