Philips AZ 1560 Handbuch Seite 7

To improve radio reception:
• For FM , pull out the telescopic aerial.
Incline and turn the aerial. Reduce its length if the signal is too
strong (very close to a transmitter).
• For MW (AM), LW , the set is provided with a built-in aerial so
the telescopic aerial is not needed. Direct the aerial by turning
the whole set.
Programming tuner stations
You can store up to a total of 30 tuner stations in the memory.
1. Tune to your desired station (see Tuning to radio stations).
2. Press PROG to activate programming.
™ Display:
3. Press PRESET 3 or 4 once or more to allocate a number from
1 to 30 to this station.
4. Press PROG again to confirm the setting.
™ Display:
of the preset station are shown.
5. Repeat the above four steps to store other stations.
• You can overwrite a preset station by storing another frequency
in its place.
Tuning to preset stations
Press TUNER PRESET 4 or 3 until the desired preset station is
displayed.
Changing tuning grid (some versions only)
In North and South America the frequency step between adjacent
channels in the AM and FM band are 10 KHz and 100 KHz
respectively. In the rest of the world this step is 9 KHz and 50 KHz.
Usually the frequency step has been preset in the factory for your
area.
1. Check that the set is in the TAPE/OFF position and switched
off.
2. To select 9KHz: Simultaneously, press PROG and REPEAT
3. Switch the set on to TUNER and then release the controls.
• To select 10KHz: Repeat steps 1-3 but in step 2 ,
simultaneously, press PROG and TUNING § on the set.
™ When you tune to radio stations, the display shows tuning in
either steps of 9 or 10.
™ All preset stations will be affected and you may need to
reprogramme the preset stations.
Downloaded from www.Manualslib.com
flashes.
PROG
disappears, the preset number and the frequency
PROG
manuals search engine
AZ 1560/00 7
page
DIGITAL TUNER
7