Care And Cleaning; Service And Customer Care - Kenwood IC550 serie Handbuch

Downloaded from www.Manualslib.com
PTFE soleplate
A PTFE soleplate ICSP01 is not
included in pack but can be
purchased separately by contacting
the shop where you purchased the
steam station.
The soleplate can be fitted when
ironing delicate items such as silk.
steaming the creases out of
curtains, hanging clothes,
wall hangings
1 Make sure there is water in the tank.
2 Turn the temperature control to
.
3 When the green ready to steam light
glows pull the material slightly with
one hand: hold the iron upright with
the other.
4 Tilt the iron forwards, then move it
down the material, pressing the
steam button.
●
Never steam clothes being worn.
Keep your hands away from the
steam and soleplate.
●
Always ensure that the iron is facing
away from the user and/or others
when vertical steaming.
●
For material other than linen or
cotton, keep the iron off the material
to avoid burning it.

care and cleaning

●
Always switch off, unplug and allow
to cool overnight before cleaning or
storing.
●
Empty the water tank.
●
When carrying the unit, always lift
from underneath and make sure the
iron is secure before moving.
the outside
soleplate
●
Don't scratch the outside by ironing
anything hard eg zips.
●
To remove minor remains of material
stuck to the soleplate, rub
lengthways with a soft, damp, non-
metallic cleaning pad.
manuals search engine
casing
●
Wipe with a damp cloth.
the inside
important
To extend the life of your steam
station and to avoid a build up of
scale, it is essential that you rinse
out the boiler after every 10 refills or
once a month. If you live in a hard
water area increase the frequency of
cleaning. Do not use chemical
descaling agents or vinegar as they
may damage your appliance.
●
Clean the boiler making sure it has
been allowed to cool overnight first.
Turn the steam station upside down
and pull back the flap covering the
boiler cap . Unscrew the boiler
cap using a coin and empty out any
water. Add one cup of tap or filtered
water and shake the appliance then
empty out all the water. Repeat this
operation until the water from the
boiler comes out clear and clean.
When cleaning is finished pour
500ml fresh tap or filtered water into
the boiler and screw the boiler cap
back on again without using
excessive force. Replace the cover.
The unit is now ready to use.
important: Aways add 500ml
water direct to the boiler after
cleaning to prevent damaging the
steam station.
service and customer
care
●
If the cord is damaged it must, for
safety reasons, be replaced by
KENWOOD or an authorised
KENWOOD repairer.
If you need help with:
●
using your appliance
●
servicing or repairs
Contact the shop where you bought
your appliance.
5