trig TY96 Bedienungsanleitung Seite 7

EN
GPS Database
If it has been configured in your aircraft, there is a third database in the radio.
This is loaded by your GPS receiver and will contain airfields appropriate to
your current route of flight.
It is accessed exactly the same way as the built in database, except that you
first select the remote data source using the large knob (to highlight the
database field) and the small knob (to select the GPS data source).
The only difference is that airfield identifiers are usually ordered by how close
they are to your route, rather than alphabetical order.
Entering New Frequencies
You can add station identifiers and frequencies to the internal database, which
stores up to 250 entries. To edit the database, go into memory mode by
pressing the MEM button, then press and hold the MEM button for 5 seconds.
The screen will change to highlight the top field which will offer the choice of
EDIT, DELETE, ADD NEW and CANCEL.
To add a new database entry, select ADD NEW, and then press MEM again.
Use the large knob to move the highlighted cursor, and use the small knob to
select characters, numbers or facility type. Pressing the MEM button again
stores the new value, and returns to the normal memory mode.
If you already have entries in the database, you can edit them to change the
details, or you can delete them. To do that, first find the entry that you want to
edit or delete using the normal memory mode. Then, with the entry you want
to change displayed, press and hold the MEM button for 5 seconds. The
choices described earlier will be offered; EDIT, DELETE, ADD NEW or CANCEL.
If you choose EDIT, and press MEM, the cursor can alter characters, numbers or
facility type in the current entry. Pressing MEM will save that changed entry. If
you choose DELETE, and press MEM, the current entry will be deleted.
5