Installation Example; Commissioning, Operation; Display; Switch Point Setting - elector μS-Control 6C Gebrauchsanweisung

Conductivity meter µS-Control 6C
Chapter 3 – Commissioning / Operation

3.1 Installation example

Install the conductivity sensors depending
on the application in direction of flow before or after
the ion exchange cartridge. Immerse the sensors as
deep as possible in the medium.
ATTENTION: The sensors must not come into
contact with the walls of the pipe.
3.2 Comissioning
Install the conductivity sensors at the measuring points of your choice before you switch on the
device. Suitable flow cells for installation of the sensors made of PVC-U and stainless steel are
available from us.
Make sure that there are no open cable ends at the switch contact or that the external device or
signal parts are properly connected before you switch on the device.
The device is switched on automatically as soon as you plug the power supply into a power
socket.
The device immediately starts measuring the conductivity.

3.3 Display

The display shows the electrical conductivity in the unit µS / cm and alternately the temperature
in °C.
The electrical conductivity can be measured in a range of 0 - 199.9 µS / cm.
If the measuring range is exceeded, the text OFL appears on the display.
3.4 Switching point adjustment
The device has various preprogrammed switching points that can be selected by turning a coded
rotary switch.
This rotary switch is located on the left side of the housing. Turn it with a screwdriver. The
selected switching point is shown on the display for 3 seconds and is activated automatically.
The function of the switching point is based on the measured electrical conductivity of the water.
The signal LD in the housing changes its color from green to red, as soon as the switching point
is exceeded. The switch contact is turned off as well.
Page 13 www.elector-water-treatment.com