Safety Regulations; Disclaimer - elector μS-Control 6C Gebrauchsanweisung

Conductivity meter µS-Control 6C

1.4 Safety regulations

The commissioning of the conductivity meter may only be carried out by specialist personnel.
The manufacturer's instructions for maintenance and replacement of the consumables in the
system must be observed.
The manufacturer's warranty is void if the device is modified.
The manufacturer accepts no liability for damage caused by improper commissioning. It also
voids the warranty.
The conductivity meter must not be operated in potentially explosive areas.
The conductivity meter may only be put into operation if it is in perfect condition.
The conductivity meter may only be operated in aqueous solutions with a pH value of 4 - 12. Use
in concentrated acids and alkalis is not permitted.
Check the device for possible damage before commissioning.
The intended use within the performance limits must be ensured.
Before carrying out any repair work, the device must be disconnected from the power supply.
Damaged devices must be taken out of operation immediately. Have defective or damaged
devices repaired only by specialists authorized by the manufacturer. It is in your own interest. This
prevents defective repairs.

1.5 Disclaimer

Use must be carried out exactly as described in this manual. The manufacturer is not liable for
any damage, including consequential damage, that may result from incorrect installation or
incorrect use of the product.
www.elector-water-treatment.com Page 10