General Information / Safety Instructions; General Information; Field Of Use; Safety Instructions - elector μS-Control 6C Gebrauchsanweisung

Conductivity meter µS-Control 6C
Chapter 1 - General Information / Safety Instructions

1.1 General Information

The conductivity meter µS-Control 6C is used to measure the electrical conductivity of aqueous
solutions.
All functional parts are made of corrosion-resistant stainless steel and high-quality plastic and
electronic components. All materials correspond to the state of the art.
The information in this user manual enables you to operate the device safely, properly and
economically. In particular, basic information on installation, operation and maintenance must be
observed.
Every person who works with this device must read and apply these operating instructions.
In addition to the operating instructions, the current and locally applicable regulations for accident
prevention and for safe and professional work must be observed.
These operating instructions must always be available at the place of use.

1.2 Field of use

This conductivity meter is used to measure the electrical conductivity in aqueous solutions,
especially in applications in which deionized water is used. It has an internal circuit for the voltage
supply of external electrical devices. No other application is permitted.

1.3 Safety instructions

Improper handling of the device can cause a lethal electric shock and damage or destroy the
device. Read the instructions for the device and keep them for later use.
Liquids entering the housing can result in a life-threatening electric shock and damage or destroy
the device. Operate the device only in the environment corresponding to the protection class.
Damaged connecting cables, open contacts and cable ends as well as damage to the housing
and the device itself can lead to a lethal electric shock. Connect the cables of the device only to
the designated sockets. Replace damaged cables immediately.
Repairs may only be carried out by a specialist. Please contact a qualified electrician or the
manufacturer.
Do not touch the contacts with skin or with pointed metallic and damp objects.
Important note: Touching the sensor for conductivity measurement is harmless! Only a low
current is used to measure the electrical resistance.
Page 9 www.elector-water-treatment.com