EasyGO CANNY Gebrauchsanweisung Seite 11

8. The repair method shall be determined by the guarantor,
9. The product subject to a complaint should be provided
clean,
10. The warranty is valid within the European Union,
11. The consumer goods warranty does not exclude or
suspend the purchaser's rights stemming from goods non-
compliance with the agreement.
OPERATION MANUAL
UNFOLDING THE STROLLER
To unfold the stroller release the automatic lock (fig. 1) and pull the
stroller guiderail upward until fully unfolded (fig. 2).
ATTENTION! Make sure the stroller is opened correctly prior to
use.
ATTACHING AND REMOVING WHEELS
To attach the front wheels, push their hubs into the mounts on
the ends of the front tubes (fig. 3). To remove the wheels press
the button on the back of the wheel mounts and slide the hubs
out. To attach the rear wheels, push their hubs into the mounts on
the rear suspension (fig. 4). To remove the wheels press the metal
button on the bottom of the wheel mounts and slide the hubs out.
ATTENTION! Make sure the wheels are correctly attached prior to
use.
ARTICULATED FRONT WHEEL SYSTEM
The stroller has articulated front wheels, which may also be locked
in a forward facing position. To release the wheels, the lever found
in the front part of the wheel should be set to down position (fig.
5). To lock the wheels in a front facing position, the lever found in
the front part of the wheel should be set to up position (fig. 6).
SAFETY BRAKE
The stroller is equipped with a safety brake. In order to lock it, press
the brake foot located at the right rear wheel of the stroller (fig. 7).
In order to release it, lift the brake foot (fig. 8).
NOTE! The stroller brake is not applied to slow down the stroller.
Use it only when stationary.
NOTE! Never leave a child in the stroller without the brake
activated.
ASSEMBLY AND REMOVING THE CANOPY
In order to assembly the canopy, insert its hooks on the handles on
the stroller frame (fig. 9). Set the canopy in the desired position (fig.
10). The canopy is equipped with additional part with ventilation
grid. In order to reveal it, unzip the top of the canopy.
ASSEMBLY AND REMOVING THE BAR
In order to assembly the bar, insert its hooks on the handles on the
seat side tubes (fig. 11). In order to remove it, push the buttons
located in the lower part of the handles and slide the clips out (fig.
12). There is no need to remove the bar before folding the stroller.
NOTE! Never move the stroller by holding the bar.
NOTE! Using the bar does not exempt from the obligation to use
the seat belts.
FOOT REST ADJUSTMENT
In order to lower the foot rest, press the round buttons on its sides
(fig. 13). In order to raise the foot rest, just push it upwards.
NOTE! The foot rest is to support the legs of a child. If a child is in a
sitting position, the foot rest must be lowered.
BACKREST ADJUSTMENT
The stroller has 3-step adjustment of the backrest. In order to
lower the backrest, pull the lever on the rear of the backrest and
set the desired position (fig. 14). In order to raise the backrest, just
push it upward. It locks automatically in that position.
ADJUSTING THE HEIGHT WITH THE HANDLE
The push chair has a telescopic height adjustment handle. To make
adjustments, press the button in the central part and then set to
the correct height (fig. 15).
SAFETY HARNESS
The pram has a five point safety harness appropriate for children
from birth.
The shoulder straps should be adjusted to the child's age. There
are two pairs of slots in the backrest for the shoulder straps. The
lower slots should be used for children less than six months old.
The upper slots should be used for children more than six months
old (fig. 16).
To put the five point safety harness on, connect the shoulder straps
with the hip straps and then slot them into the central buckle
attached to the groin strap. Adjust all the straps and belts so that
they are snug with the child's body but at the same time are not
uncomfortable (fig. 17, 18, 19).
To open the harness press the button on the central buckle and
disconnect all straps (20).
ATTENTION! If the pram is used to carry a child less than 6 months
old, the backrest has to be in a "lying down" position.
FOLDING THE PRAM
To fold the pram, open the textile flap on the seat (fig. 21). Then
straighten the plastic lever (fig. 22) vertically and pull it upwards
(fig. 23). Lift the pram up by holding the lever (fig. 24). Press the
pram down to engage the locking mechanism (fig. 25).
en
11