Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
7.2. Setpoint (Display and modification of desired temperature value)
•
Press button
•
By keeping button
minumum SPL and the maximum SPH limit).
•
When button
7.3. Turning on
•
Plug the electric plug of the equipment to grounded outlet.
•
Start up your equipment via the on-off switch.
•
If your equipment has forced cooler turn on its fan.
•
Do not open the doors until your equipment enters into regime.
•
Adjust your equipment to the desired degree through the cooler control device on the control panel.
7.4. Turning off
•
Switch the on-off switch to "Off" position.
•
Unplug.
8. CLEANING AND MAINTENANCE
•
Be absolutely sure that the equipment is unplugged before commencing cleaning or maintenance
activity on the equipment.
•
For cleaning use a cleaning cloth dipped into warm water and an odourless detergent of a type that
does not harm food.
•
Never use detergents having abrasive ingredients or wire brushes that may scratch inner or outer
surfaces of the equipment.
•
Since the dust accumulated on the condenser affects the efficient operation of the equipment, remove
the dust on or near the condenser with a soft brush or a vacuum cleaner once in every two weeks.
(Figure-1)
•
Fan motor is required to be oiled no more than once in every two weeks (this period may be shortened
depending on the environment). Not maintaining the condenser and the fan motor decreases the
efficiency of the equipment and may cause the compressor to burn out.
•
Occurrence of excessive icing on the evaporator (cooler core) of the refrigerator is a factor that
decreases the efficiency of the equipment and cause problems. In order to keep your equipment
efficient and with a long lifecycle defrost the equipment when icing occurs.
•
Do not clean the equipment with direct or high pressure water. Otherwise you may cause an electric
wiring defect.
•
In case of observing any hazardous situation immediately inform authorized service. (For reference
indicate your equipment's serial number and model both written on the label on the side of the
equipment). Do not allow interference on the equipment by unlicensed persons. Otherwise your
equipment will not be covered by warranty.
•
Also the repairs and maintenances of any defect that may be caused by negligence of the maintenance
activities you are supposed to carry out are subject to relative fees.
•
If the equipment will not be used for a long duration unplug it, take out any food in it, for avoiding
oxidation clean the complete interior surface with a disinfectant not harmful to food, leave its doors
open for avoiding molding and smell, cover it for preventing dusting.
for at least half second , to display the setpoint value,
pressed , use button
is released , the new value is stored.
www.combisteel.com
or
set the desired value (adjustment is within the
8
Werbung
Inhaltsverzeichnis
