LOTRONIC PARTY-ROCKER Bedienungsanleitung Seite 5

NOTES
If you are connected to the Line Out Jack of your external device, you only need to adjust the volume control on
the unit. If you're connected to the Headphone Jack of your external device, you may need to adjust both the
volume control of your external device and the PARTY-ROCKER to reach the desired level.
If you use the AUX IN function when playing music from the Bluetooth device, the sound will be mixed as long as
the AUX lead is plugged in. We recommend to stop playback or disconnect the Bluetooth device when playing
music via the AUX jack.
USE OF THE USB CHARGING PORT
The USB charging jack delivers a voltage of 5Vdc 1A. Please refer to the manual of your portable device to
make sure that the voltage and current doesn't exceed the acceptable charging current of your device.
The USB charging port is only designed for smartphones and other portable devices. It cannot support data
transfer or connection to a computer.
Do not connect the USB port of this unit to another external power charger USB port. It may damage both units
and void the warranty.
1. Connect the unit to the mains via the supplied 12Vdc 2A mains adaptor.
2. Plug one end of the USB cable (not supplied) to the USB CHARGER port located on the rear panel of the unit.
Plug the other end into the device you wish to charge.
3. Unplug the cable when your device is charged.
PROBLEM
No charging
No sound
No sound when playing
audio via Bluetooth
No sound from the
microphone
No sound in AUX mode
©Copyright LOTRONIC 2017
POSSIBLE CAUSE
Portable device is not installed
properly.
Portable device is locked up or
frozen.
Portable device battery has
problem.
Power Adaptor disconnected or
loose.
The AC outlet has not power.
Volume set too low.
Your Bluetooth device has been
paired properly.
The unit placement out of
range.
The volume control of your
Bluetooth device is set at too
low.
The volume control of the unit
is set at too low.
Mic. Level control too low.
Mic is off.
The Mic is not securely
connected to the Mic jack.
Volume at minimum.
External device not connected
properly.
PARTY-ROCKER
SOLUTION
Remove your portable device from the charging
cord and check for obstruction on the
connectors.
Please make sure your portable device is
working properly before plugging into the unit.
Please refer to your portable device manual for
details.
Check the connection or the Power Adaptor.
Try the unit on another outlet.
Turn the volume control to increase the sound
level.
Pairing your Bluetooth device according to the
"Pairing a Bluetooth Device for the First Time"
section.
Relocate the unit within Bluetooth operating
range (10m).
Increase the volume of your Bluetooth device.
Increase the volume of the unit to turn to your
wish.
Adjust Mic Level control to max, and then re-
adjust to a comfortable level.
Switch Mic to the ON position.
Securely connect the Mic to the Mic jack.
Adjust the volume knob.
Clear contacts pins and connect again.
5