LOTRONIC PARTY-ROCKER Bedienungsanleitung Seite 4

GUITAR CONNECTION
Plug the 6.3mm Guitar plug (or other high impedance instrument) into the GUITAR IN jack on the rear side of your
unit. Their output is mixed with playback from BLUETOOTH or AUX IN.
AUDIO OUTPUT CONNECTION
Please follow the steps below to connect audio signal from the unit to your home audio system.
1. Connect the white and red plugs of the RCA lead (not supplied) to the white and red AUDIO OUT jacks of the
back panel of the unit.
2. Connect the other ends of the RCA lead to the red and white connectors of the external unit's audio input.
ECHO control
Adjust the ECHO control to enhance the singers' voice for a concert hall effect.
Light Effect
Press PARTY LIGHT ACTIVATE button to switch on the light effect. Press again to turn off. If you want to
change the mode of the light show, press the PAIRING button.
Pairing a Bluetooth Device for the First Time
Power on the unit by pressing the STANDBY button. The power indicator will light up and the Bluetooth indicator
will flash. Press and hold the PARING button for about 5 seconds. When pairing, remain within 1m of the unit.
Activate the pairing function on your Bluetooth device and select "PARTY-ROCKER" in the list of found devices. If
requested enter the default password 0000.
When successfully paired and connected, a sound "Connected" will issue from the unit and the Bluetooth
indicator will remain lit.
After the initial pairing, the unit will stay paired unless unpaired manually by the user or erased due to a reset of
the device. If your device should become unpaired or you find it is unable to connect, repeat the above steps.
Wireless Audio Play
After pairing a Bluetooth device, use the native controls of the connected Bluetooth device to select, play, pause
or skip tracks.
Adjust the volume to the desired level.
Press STANDBY button to switch the unit off.
Playing an AUX Source
You can play other music sources (iPod, MP3 or other digital audio players) by connecting the AUX IN jacks to the
audio out jack of an external unit.
1. Plug one end of a 3.5mm audio input cable (not included) into the AUX IN input on the rear of the unit, and
plug the other end of the cable into the audio output on the external music player or other source.
Note: Make sure your external music player is ON.
2. Press the STANDBY button to power the unit on. The power indicator will light up.
3. Start playing the device you plugged into AUX IN input. Their output is mixed with playback from BLUETOOTH
or MIC IN.
4. Slowly adjust both volume controls of the unit and the external device until you reach the desired listening
level.
5. Press the STANDBY button again to turn the unit off. Don't forget to power off the external unit.
©Copyright LOTRONIC 2017 PARTY-ROCKER 4