Babytalker 1030
-
Open the battery compartment.
-
Insert the three AAA batteries/rechargeable
batteries (LR03). Make sure that you observe
the correct polarity.
-
Close the battery compartment.
11.4.2 Connecting the baby unit to the AC
mains
- Plug the small connector of the power adapter into
the power adapter jack
unit. A click indicates, the jack is locked into
position.
- Connect the power adapter (7.5 V
to a mains socket (230-240 V~ 50 Hz).
•
Only use the enclosed power adapter.
11.4.3 Installing rechargeable batteries in the
parents' unit
WARNING
Injury and material damage can be caused by using
non-rechargeable batteries in the parents' unit!
•
Only use the Ni-MH battery pack supplied with
the product.
•
Remove the batteries if the device is to
remain unused for an extended period.
•
The parent unit can only be used with the
enclosed Ni-MH battery pack. It cannot be
used with single cell Ni-MH batteries!
-
Remove the belt clip.
-
Push the battery cover
-
Insert the battery pack. Make sure that you observe the correct polarity.
-
Re-install the battery cover
on the side of the baby
22
300 mA)
and slide it downwards.
13
and belt clip.
13
1 x AAA
-
+
1 x AAA
Ni-MH
MUST BE RECYCLED OR DISPOSED OF PROPERLY
MADE IN CHINA
57