Technical Specifications - 3M Accuspray HGP Benutzerhandbuch

To reduce the risks associated with impact from an atomizing head projectile:
• Always inspect to ensure that the atomizing head is securely in place and test the spray gun for
possible obstruction prior to each use.
To reduce the risks associated with sharp point:
• Do not touch the sharp end of the fluid needle when exposed and handle fluid needles carefully
during replacement.
To reduce the risks associated with muscle strain:
• Avoid using spray equipment continuously without taking occasional breaks.
To reduce the risks associated with property damage:
• Do not maintain or service the spray gun other than as instructed in the user's manual.
To reduce the risks associated with environmental contamination:
• Spray materials, solvents, other cleaning materials and electronic components must be disposed
of per federal, state and local regulations.

Technical Specifications:

Operator Hand/Arm Vibration level: less than 2.5 m/s²
Declared vibration level in accordance with EN 12096, measurements carried out in accordance with
standard EN ISO 28662-1 and EN ISO 20643.
Declared Dual-Number Noise Emission Values according to EN ISO 4871
A-WEIGHTED EMISSION SOUND PRESSURE LEVEL AT THE WORKSTATION:
Measured value: LpA = 71,4 dB(A) (ref 20μPa)
Uncertainty: KpA = 2,5 dB
A-WEIGHTED SOUND POWER LEVEL:
Measured value: LWA = 83,1 dB(A) (ref 1 pW)
Uncertainty: KWA = 2,5 dB
Values determined according to noise test code EN 14462 using the basic standards
EN ISO 11201 - grade 2, and EN ISO 3741
Usage Rated - II 2G Ex h IIB T4
IMPORTANT NOTE: The noise and vibration values stated are from laboratory testing in conformity with
stated codes and standards and are not sufficient risk evaluation for all exposure scenarios. Values
measured in a particular work place may be higher than the declared values. The actual exposure values
and amount of risk or harm experienced to an individual is unique to each situation and depends upon the
surrounding environment, the way in which the individual works, the particular material being worked,
work station design, as well as upon the exposure time and the physical condition of the user. 3M cannot
be held responsible for the consequences of using declared values instead of actual exposure values for
any individual risk assessment.
For the most up-to-date version of this manual, please visit your local 3M Collision website.
CAUTION
6