Cleaning And Storage - Ayce F 20 L Gebrauchsanweisung

POWER: Press power button once to turn on/ off the power.
HUMIDITY READING TIMER DISPLAY: After start-up, the original
value is CO.
AIR DEFLECTOR: Turn on the device, the deflector will move to
the vertical position. Press air deflector button once, the deflector
will keep waving between 45° to 90°. Press air deflector button
again, the deflector will stop waving. Turn off the device, the
deflector will close automatically.
UP: Press up button one press at a time through the settings.
CO-30-35-40-45-50-55-60-65-70-75-80%
DOWN: Press down button one press at a time through the settings.
80-75-70-65-60-55-50-45-40-35-30-CO
Press up and down buttons at the same time 2s to activate the
child lock, repeat the same process to unlock the child lock.
TIMER: Press timer button, then press up or down button, the
value will rise/drop 1 hour with each pressing down. It ranges
from 1 to 24 hours.
FAN SPEED: Press fan speed button once to change fan speed
between high « » and low « ».
TANK FULL LIGHT: Tank full light flashes when the tank is full,
and the device goes into standby mode. Empty the tank, the device
will go on to the original mode.
DEFROST LIGHT: When the device is in standby mode, running
light flashes slowly, when the device is in working mode, running
light will be always on. During defrosting, the light flashes quickly,
after defrosting, the light will be alwayson.

CLEANING AND STORAGE:

Cleaning:
When used regularly, the filter may become clogged with dust and particles.
Therefore, the filter should be cleaned at least every two weeks. Follow these steps:
1. Switch the device off and remove the plug from the socket before cleaning.
2. Clean the housing with soft, dry cloth. If the device is extremely dirty, use a mild
cleaning agent. Wipe the dehumidifier with a slightly damp cloth. Never spray the
device with water.
3. Remove the filter, clean the filter with a vacuum cleaner or soapy water no hotter
than 40°C.
4. Rinse and dry the filter completely before installing back to the device.
Storage:
If the dehumidifier will not be used for a long period of time, take the following steps:
1. Remove the plug from the socket and empty the tank make the tank and the
dehumidifier, dry completely, this may take a couple of days.
2. Clean the air filter.
3. Check the dehumidifier for perfect condition to ensure a safe use of it after a long
period of storage.
4. Pack the device with the suitable packaging.
5. Store the dehumidifier in a dust-free and out of direct sunlight location, preferably
covered with a sheet of plastic.
44 | 45 GB