Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
6.
Maintenance
Top up hydraulic oil
Wear safety goggles
Follow correct sequence!
•
Disconnect the processing tool from the compressed air supply
•
Slacken off setscrew (No. 7)
•
Remove circlip (No.4)
•
Push back C-frame to remove pin from head module (No. 5)
•
Unscrew split bushing (No. 8) and stroke limiter (No. 6) from tool head (No. 9)
•
Unscrew oil screw plug (No. 10) and seal (No. 11) with T20 Torx screwdriver
•
Screw on and hold supplied oil refill reservoir with cover
•
Connect processing tool to compressed air supply and press trigger (No. 37); then disconnect
processing tool from compressed air supply
•
Pour used oil out of oil refill reservoir
•
Fill oil refill reservoir up to the mark with hydraulic oil
•
Carefully move the pull piston unit back and forth by hand until bubble-free oil flows out; push
back the pull piston unit as far as it will go and leave in this position
•
Unscrew oil refill reservoir and screw in oil screw plug (No. 10) with seal (No. 11)
•
Connect the processing tool to the compressed air supply
•
Carefully undo oil screw plug (No. 10) by 2 turns; the pull unit moves slowly into the front end
position. Collect leaking oil in a rag
•
Tighten oil screw plug (No. 10)
•
Reassemble in reverse order and screw all parts together.
Regular maintenance will extend the service life of your high-quality GESIPA
and they should be serviced at least every 2 years by an authorised workshop or by
GESIPA
Service. We recommend servicing tools that are subject to intensive use
®
ahead of schedule.
7.
Storage
The blind rivet setting tool should be stored in a dry place where there is no danger of frost.
16
Danger of oil escaping at high pressure.
tools
®
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
