Blowing; After Finishing Work; Transporting; Transporting The Blower - Stihl BGA 86 Gebrauchsanleitung

12 After Finishing Work

► Hold and guide the blower by the control handle with one
hand, wrapping your thumb around the control handle.

11.2 Blowing

► Point the nozzle at the ground.
► Move forward slowly, in a controlled manner.
12 After Finishing Work
12.1 After finishing work
► Switch off blower and remove battery.
► If the blower is wet: allow blower to dry.
► If the battery is wet: allow battery to dry.
► Clean blower.
► Clean battery.

13 Transporting

13.1 Transporting the blower

► Switch off blower and remove battery.
► Carry blower by the control handle in one hand.
► If transporting the blower in a vehicle: Secure the blower
so that it cannot topple over and cannot move.
0458-824-9821-A

13.2 Transporting the battery

► Switch off blower and remove battery.
► Check that the battery is in a safe condition.
► Pack the battery in such a way that the following
conditions are fulfilled:
– The packaging is electrically non-conductive.
– The battery cannot move inside the packaging.
► Secure the packaging so that it cannot move.
The battery is subject to the Carriage of Dangerous Goods
regulations. The battery is classed as UN 3480 (lithium ion
batteries) and has been tested in accordance with the UN
Manual of Tests and Criteria Part III, Subsection 38.3 .
The transport regulations can be found in
www.stihl.com/safety-data-sheets.

14 Storing

14.1 Storing the blower

► Switch off blower and remove battery.
► The blower should be stored in such a way that the
following conditions are fulfilled:
– The blower is out of the reach of children.
– The blower is clean and dry.

14.2 Storing the Battery

STIHL recommends that you store the battery with a charge
between 40% and 60% (2 LEDs glow green).
► Observe the following points when storing the battery:
– Battery is out of the reach of children.
– Battery is clean and dry.
– Battery is in an enclosed space.
– Battery is stored separately, away from the blower and
charger.
– Battery is in non-conductive packaging.
– Battery is in a temperature range between -10°C and
+50°C.
English
33