Panasonic AJ-YAC960P Installationsanleitung Seite 2

SDTI Interface Board
Introduction
AJ-YAC960P
The AJ-YAC960P is an SDTI interface board designed to be used with the AJ-D960. By installing it in the AJ-
D960, digital data can be input and output using the SDTI format*
*1: SDTI (serial data transport interface) complies with the SMPTE 305M standard.
The format of the data streams sent using the SDTI interface complies with the SMPTE 321M standard.
Refer the installation of the SDTI interface board to qualified service personnel. The VTR's software may
need to be upgraded or its hardware changed.
Connector area
Serial digital input connectors (BNC x 2)
1 Input : Used for both SDTI and SDI signals
2 Active through output
Serial digital output connectors (BNC x 3)
3 Output 1 : Used for both SDTI and SDI signals
4 Output 2 : Used exclusively for SDI signals
5 Output 3 : Used exclusively for SDI signals
1 Input connector used for
both SDTI and SDI signals
2 Active through output
connector
(compression digital interface).
1
SERIAL IN SERIAL OUT
1
3 Output connector used for
both SDTI and SDI signals
2
4 Output connector used
exclusively for SDI signals
3
5 Output connector used
exclusively for SDI signals
E-1