Inhaltsverzeichnis; Safety Precautions; Cover Removal; Introduction - Philips LTC 2814/90 Installationshinweise

SAFETY PRECAUTIONS

CAUTION: TO REDUCE THE RISK OF
ELECTRICAL SHOCK, DO NOT OPEN COVERS.
NO USER SERVICEABLE PARTS INSIDE. REFER
SERVICING TO QUALIFIED SERVICE
PERSONNEL.
This label may appear on the bottom of the unit due to space
limitations.
The lightning flash with an arrowhead symbol,
within an equilateral triangle, is intended to alert
the user to the presence of un-insulated
"dangerous voltage" within the product's enclosure
that may be of sufficient magnitude to constitute a
risk of electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to presence of
important operating and maintenance (servicing)
instructions in the literature accompanying the
appliance.
WARNING
TO PREVENT FIRE OR SHOCK HAZARD, DO
NOT EXPOSE UNITS NOT SPECIFICALLY
DESIGNED FOR OUTDOOR USE TO RAIN OR
MOISTURE.
Attention: Installation should be performed by
qualified service personnel only in accordance with
the National Electrical Code or applicable local
codes.

COVER REMOVAL

WARNING:
REMOVAL OF THE COVER
SHOULD ONLY BE PERFORMED
BY QUALIFIED SERVICE
PERSONNEL - NOT USER
SERVICEABLE. THE UNIT SHOULD
ALWAYS BE UNPLUGGED,
BEFORE REMOVING THE COVER
AND REMAIN UNPLUGGED
WHILE THE COVER IS REMOVED.
CONTENTS
Safety Precautions . . . . . . . . . . . . . . . . . . . . . . . . .1.1
Cover Removal . . . . . . . . . . . . . . . . . . . . . . . . . . .1.1
1. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.1
1.1 Monitor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.1
2 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.1
2.1 Ventilation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.1
2.2 Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.1
2.3 Connecting the Composite Video Signal to the
Monitor . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.2
2.4 Connecting the Y/C Signal to the monitor . . . . . . .1.2
2.5 Connecting Audio to the Monitor . . . . . . . . . . . . .1.2
3 Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1.2
1

INTRODUCTION

1.1 Monitor
Read these instructions carefully.
This 14 inch (viewable picture area 34 cm (13.3 inch)) monitor
is intended for display of PAL or NTSC standard color pictures
in CCTV systems. The monitor accepts either two Composite
Video inputs, with loop-through BNC connections, or one Y/C
loop-through input, with two 4-pin mini-DIN connectors,
located on the rear of the monitor.
The Composite Video-Y/C switch is located at the front.
For applications that require audio, two audio phono jack
connectors are provided on the rear panel.
2 INSTALLATION
Up to three monitors can be connected using the loop-through
feature of this unit (Fig. 3).
When this monitor is connected to additional monitors, the
same picture can be obtained on all the connected monitors.
2.1 Ventilation
In order to prevent overheating, ensure that the ventilation
openings in the monitor are not covered.
2.2 Power
Model Rated
No. Voltage
LTC 2814/90 120/230 VAC
50/60 Hz
The LTC 2814/90 monitor is delivered with a 2 pole Euro
connector and a 3 pole US style connector.
1.1
Voltage Power at Sync
Range Rated Voltage Format
100 to 240 70 W PAL/
NTSC